JEPMC-PS050

详情描述：

JEPMC-PS050

JEPMC-PS050

JEPMC-PS050

PLC系统分为逻辑电路接地和功率电路接地，有共地、浮地及机壳共地和电路浮地等三种方式。一般采用控制器与其它设备分别接地方式好，接地时注意:接地线尽量粗，一般大于2mm2的线接地;接地点应尽量靠近控制器，接地点与控制器之间的距离不大于50m;接地线应尽量避开强电回路和主回路的电线，不能避开时，应垂直相交，应尽量缩短平行走线的长度。
实践证明，接地往往是抑制噪声和防止干扰的重要手段，良好的接地方式可在很大程度上抑制内部噪声的耦合，防止外部干扰的侵入，提高系统的抗干扰能力。


          APPLIED MATERIALS 0150-09196 ASSY CABLE SYSTEM TCS NEW                                        
                                                  
          APPLIED MATERIALS 0140-20694 HARNESS ASSY PVD SHUTTER                                         
                                                  
          Applied Materials AMAT Chopper Drive P W B 0100-00011                                        
                                                  
          NEW AMAT Applied Materials 0190-10257 300mm I-Cu Anode                                        
                                                  
          APPLIED MATERIALS 300MM REFLEXION LDM EXHAUST STIF HOSE                                        
                                                  
          AMAT Applied Materials Chamber 5000 CVD A079C                                        
                                                  
          Applied Materials 0100-00196/Micro Memory Inc. MM-6000                                        
                                                  
          Applied Materials 0100-00137/Micro Memory Inc. MM-6500                                        
                                                  
          AMAT Applied Materials 0100-11022/Mizar 75801 SIO Rev C                                        
                                                  
          AMAT Applied Materials 0100-00012 VME Counter Board                                        
                                                  
          AMAT Applied Materials 0010-00019 Analog Power Supply                                        
                                                  
          Applied Materials Power Supply 9090-00203ITL                                        
                                                  
          Applied Materials Booster Control Chassis 9090-00742                                        
                                                  
          30th Anniversary POSTER Applied Materials DYLAN/Wonder                                        
                              
          AMAT Applied Materials 0100-11002 Digital I/O Board                                        
                                                  
          NEW Applied Materials Red Lion p48+RS232 OEMNMCB3 32072                                        
                                                  
          Applied Materials 0730-01049 Turbo Pump Controller AMAT                                        
                                                  
          Applied Strength of Materials by Robert L. Mott (200...                                        
                                                  
          Applied Materials AMAT 300mm Leveling Jig/Gap Set Tool                                        
                                                  
          AMAT Applied Materials Mainframe Module 5000 Etch.                                        
                                                  
          Applied Materials 3620-01437 Centura Turbo Pump AMAT                                        
                                                  
          Applied Materials/AMAT 8300 RF Micro-Match 0010-00799                                        
                                                  
          Applied Statics and Strength of Materials by George ...                                        
                                        
          Applied Strength of Materials by Mott, Robert L                                        
                                                  
          AMAT/Applied Materials PN: 0190-15553 RF Generator 8kW                                        
                                                  
          Applied Statics and Strength of Materials by Thomas ...